1993 CP-19 MK III for Sale SOLD

[deweyj]

Very good condition. No work needed. Ready to Sail.

$6,500.00 including the items below.

Main sail with jiffy reefing system and new cover 2008.

130% Genoa with new CDI roller furling / reefing system  new 2008.

Very good running 1987, 9.9hp Honda longshaft 4 stroke outboard motor.

Factory galvanized trailer with lights, bunks, winch, new Grease Seals, and spare tire

Seat cushions.

Stainless steel bow pulpit, stem rail and lifelines.

Swim ladder and detachable bow ladder

All halyards and control lines lead to the cockpit.

All running rigging replaced 2008.

Mid boom traveler system.

Cockpit mounted manual bilge pump.

Floating winch handle

Factory molded non-skid on all top side surfaces.

Stern mounted stainless steel folding boarding ladder and detachable bow ladder.

Exterior teak trim 2008 with Cetol finish.

Built-in anchor roller with 81b Danforth anchor, chain and 50' rode.

Vented gas tank compartment.

Built in Compass.

Two spacious cockpit seat lockers.

Four bronze opening ports with built in bug screens.

Two cabin lockers under V berth.

Two 6' 4" quarter berths with 3" cushions. 6' 3" V berth.

Porta Potti under companionway, new 2008.

Electrical package includes: new compact deep cycle battery, navigation lights and cabin light.

All deck cleats are bronze or Harken cams.

Mast and boom are anodized aluminum with 5/32", 1x19 stainless steel standing rigging.

Bottom was factory epoxy coated with fresh 2008 VC17 anti-fouling. Hull cleaned, buffed and waxed 2008. New tape stripes on hull 2008.

Rudder bearings replaced 2008.

Aluminum kick up rudder.

Custom mast crutch for easy mast raising.

Located on trailer at Sand Springs, OK

[seawitch]

Is your boat still on the market?
Do you have photos available?

[deweyj]

The boat has been sold.