When I bought the Eclipse in the spring the CDI FF1 roller furler had been stored in such a position that it created a kink in the luff extrusion about 12" from the top. When it became clear that there was no straightening it I purchased a new extrusion. As I was storing all the gear and equipment for the winter it occurred to me that maybe someone with a smaller boat, like a Com-Pac 16 or a Legacy, could use this extrusion if they have an existing CDI. It would even be great for a backup if it were long enough.
It is the top only that was damaged. The bottom with the sail feed slot opening is as it was when new.
The measurements of the undamaged section are 213 ½" X ½" X 1 ¼".
(http://i1058.photobucket.com/albums/t403/eagleye54/P11406661.jpg)
Here is a link to the FFI documents
http://www.sailcdi.com/sailpdf/FF1%20manual%207_06.pdf
(http://i1058.photobucket.com/albums/t403/eagleye54/P11406651.jpg)
If anyone here could use it, just pay the shipping and it is yours.
Allen