Com-Pac Yacht Owners Association

General Com-Pac and Sailing Related Discussions => Boat and Hardware Modification => Topic started by: Shawn on July 22, 2011, 11:54:19 AM

Title: Easy jib sheet removal...
Post by: Shawn on July 22, 2011, 11:54:19 AM
(http://0.tqn.com/d/sailing/1/5/K/-/-/-/softshacklestep4small.jpg)

For those that use a single line for the jib sheets and want to make it easier to swap head sails the method is at:

http://sailing.about.com/od/equipmentgear/ss/softshacklehowto.htm (http://sailing.about.com/od/equipmentgear/ss/softshacklehowto.htm)

works very well. I did this last season and and it made it quite a bit easier to change headsails compared to when I was using a cow hitch on the sheets. For the smaller loop I used a piece of an old piece of 3 strand anchor rode to get it a little thicker to be sure it didn't pull through.

Shawn
Title: Re: Easy jib sheet removal...
Post by: skip1930 on July 23, 2011, 10:38:25 AM
That's pretty trick.
That should go into that "Why didn't I Think of That?" Book on sailing.

I'll have to try that. thanxWhat shall we call this knot? The 'Shawskiknotski Bend'?

skip.
Title: Re: Easy jib sheet removal...
Post by: Bob23 on July 23, 2011, 11:33:25 AM
That is neat. Iv'e used a variation of that on Koinoinas jib since I bought her but yours is a neater, more foolproof and easier to take apart version. Also works well on the flag pole for attaching the flag without the brass hooks. I have an old Snipe mast for a flagpole, finished bright and the brass hooks would damage the varnish. When I re-flag, I'll try this exaxt knot.
Bob23