Hey gang,
I'm trying to get my new to me Cp16 seaworthy and I find I am missing some hardware. I have figured most of it out but, I can't figure out what attaches my forestay to the forward chain plate (not sure if this is the right name.). Would I just put a D shackle on it? I will try to attach a Pic of what I have.
This is what I have.
BB
If I understand your question correctly, you don't need the shackle. The turnbuckle attaches directly to the bow stem plate.
Hey Paul! Thanks so much for the reply!
I realize now you cant see it from the photo but the right shackle loop is flat on the inside edge (See blown up image)... so if i used it, it would have a gap on the top (loaded side) of the chain plate hole... I would expect it would get impact loaded as the boat would rock from front to back eventually tearing into the plate or deforming the shackle ...(like putting a flat bar into a round hole and lifting the bar)
I would expect a round well fitted pin or turnbuckle to go thru the hole in the plate like on the two side stays. But I really have no idea having never seen this setup in person.
Any chance you have a picture?
Perhaps my previous owner did something weird and I just need to replace my shackle with the flat inside edge with a fully round D.
Or more likely I am missing something simple.
I believe Bristol 14 is saying you only need a clevis pin and not the "D shackle".
https://www.westmarine.com/west-marine--stainless-steel-clevis-pins--P002_060_010_002
Yup! That makes sense. Im over complicating it.
Because it was on there when I got it I would have agonised about why it was there.
Thanks guys!